Cisco DPC3941T User Manual page 51

Field Label
Mode
Security Mode
Channel Selection
Channel
Network Password
Show Network
Password
TP-0010 2
Description
Choose one of these options for the network mode:
 802.11 g/n
 801.11 b/g/n
Important:
When TKIP authentication only is selected, B/G/N Mixed
network mode is not available.
Choose one of these options for the security mode:

Open (risky)
 WEP 64 bits (5 Ascii characters or 10 Hex digits)

WEP 128 bits (13 Ascii characters or 26 Hex digits)

WPA-PSK(TKIP) (8 to 63 Ascii characters or 64 Hex digits)

WPA-PSK(AES) (8 to 63 Ascii characters or 64 Hex digits)

WPA2-PSK(TKIP) (8 to 63 Ascii characters or 64 Hex digits)

WPA2-PSK(AES) (8 to 63 Ascii characters or 64 Hex digits)

WPA2-PSK(TKIP/A ES) (8 to 63 Ascii characters or 64 Hex
digits)
 WPAWPA2-PSK(TKIP/A ES) recommended (8 to 63 Ascii
characters or 64 Hex digits)
Note: Not all wireless adapters support WPA2. WPA is
supported across a wider range of devices. Make sure to use a
"strong" passphrase. A strong passphrase is a string of random
characters at least 21 characters in length.
Automatic. Select Automatic (factory default) to have channel
selected for you.
Manual. Select Manual to select channels from the Channel
field.
When the Manual option is chosen for Channel Selection, use
this field to select a channel from 1 through 11.
Note: Only channels 1, 6 and 11 are non-overlapping channels.
Depending upon Security Mode selected, the Network
Password can have different requirements. The factory-set
password value can be found on the label located on the
bottom of your Residential Gateway.
To make the Network Password become visible to the user or
not. Every time the page is opened, this box is unchecked for
security reasons.
Configure Wireless Settings
29