Safety Belt Warning Light And Indicator Chime; Conditions Of Operation - Ford 2008 Ranger Owner's Manual

Seating and Safety Restraints
equipped), child safety seat tether anchors, and attaching hardware,
should be inspected after a collision. Ford Motor Company recommends
that all safety belt assemblies in use in vehicles involved in a collision be
replaced. However, if the collision was minor and an authorized dealer
finds that the belts do not show damage and continue to operate
properly, they do not need to be replaced. Safety belt assemblies not in
use during a collision should also be inspected and replaced if either
damage or improper operation is noted.
The energy absorbing functions may have been activated in a collision so
the restraints should be examined; if the front airbags have deployed, the
pretensioners have also deployed and must be replaced — regardless of
whether there was an occupant in the passenger seat or not.
Failure to inspect and if necessary replace the safety belt
assembly under the above conditions could result in severe
personal injuries in the event of a collision.
Refer to Interior in the Cleaning chapter.

Safety belt warning light and indicator chime

The safety belt warning light illuminates in the instrument cluster and a
chime sounds to remind the occupants to fasten their safety belts.

Conditions of operation

If...
The driver's safety belt is not
buckled before the ignition
switch is turned to the ON
position...
The driver's safety belt is
buckled while the indicator
light is illuminated and the
warning chime is sounding...
The driver's safety belt is
buckled before the ignition
switch is turned to the ON
position...
82
2008 Ranger (ran)
Owners Guide (post-2002-fmt)
USA (fus)
Then...
The safety belt warning light
illuminates 1-2 minutes and the
warning chime sounds 4-8 seconds.
The safety belt warning light and
warning chime turn off.
The safety belt warning light and
indicator chime remain off.