Web Browser Firmware Update - Monitor Audio ASB-2 Quick Start Manual

Web Browser Firmware Update

It is possible to update the firmware in the ASB-2 via
its web page. There are a number of ways to do this
and these are listed below:
i. Via Safari. If you have safari web browser
installed, click on Bonjour and then the
bookmarks tab. The ASB-2 should appear as
one of the bookmarks in Bonjour. Continue to
step 1 below.
ii. Via Computer on a Windows 7 PC. Navigate
to the Computer (Start; Computer), and click on
Network. Scroll to Media Devices and double
click on Airstream ASB-2 xxxxxx (Where xxxxxx
is the last 6 digits of its unique MAC address).
Continue to Step 1 below.
iii. Via the Control Panel on a Windows 7 PC.
Navigate to the Control Panel and select
Hardware and Sound, and then Devices and
Printers. Airstream ASB-2 xxxxxx should be
displayed under the Devices title. Double click
to bring up the Properties window. Click on the
UPnP tab and then the link next to "Webpage".
Continue to Step 1 below.
iv. Via any internet browser. This method can only
be done if the IP address of the ASB-2 is known.
If you do not already know this, it can be found
out by going to your router's control panel and
looking under attached devices (or similar). Refer
to the router's manual for help on this. Continue
to step 1 below.
v. Via any web browser. This method can only be
done if the last 6 digits of the MAC address are
known. In the address bar of the browser, type
in the following:
http://airstream-ASB-2-xxxxxx.local./index.asp
Where xxxxxx is the last 6 digits of the MAC
address.
WARNING: Do not, at any point during
the update procedure remove the power
from the ASB-2, or click back on the web
browser. Follow the on screen instructions and the
instructions in this manual.
1. Download the updated firmware from the www.
monitoraudio.com and save it to your computer.
2. Unzip the compressed file and save the three files
locally on your computer. The files are region
specific so make a not of the correct one for your
region.
24
3. Connect to the ASB-2 using one of the 5 methods
outlined above and click on the Firmware Update
tab.
4. Click on the drop down menu next to 'Update
Method' and select the only option available which
is "Firmware Update From Network".
5. Click on Ok. The page will change with a note to
say it should refresh in a couple of seconds, or
click a link. Click the link (if it doesn't refresh).
6. The LED on the ASB-2 will turn white.
7. Next, click on "Choose File" and navigate to the
location the updated firmware file was saved to.
Select it and click open.
8. Click on "Upload".