Advertisement
Termination
The iCANnet link is a 'daisy chain' protocol that requires
termination on the devices located at either end of the
chain.
Device
Device
The Revio wall station is supplied with termination ena-
bled as standard. If the Revio wall station is not con-
nected as an end device in the chain, you need to disable
termination.
To disable termination, move the jumper from the upper
two pins to the lower two pins, as shown here:
Termination on
Device
Universal
Source
Controller
Termination off
Reassembling the wall station
1. Locate the upper slot on
the rear of the wall station
main body, place the
upper slot onto the
corresponding
'lip' of the rear
chassis plate.
2. Angle the lower part of the main body down so that it
fits closely against the rear chassis plate.
3. Insert and lightly tighten the
two retaining screws.
4. Place the insert sheet into position.
5. Attach the top edge of the front
cover to the main body.
6. Angle the front cover down and
press the lower part of it against the
main body until it clicks into place.
Advertisement
