Advertisement
Disassembling the wall station
1. On the underside of the front cover, beneath the rotary
dial, locate the small central recess. Carefully insert a
small implement (such as a pen or screwdriver) into
the recess and lever the front cover gently away from
the main body.
2. Unclip the front cover from the top of the main body.
3. With the front cover
removed, lift off the
insert sheet.
4. Remove the two retaining screws located just below
the rotary dial and lift the base of the main body away
from the rear chassis plate until it disengages.
5. Store all removed parts safe from damage.
Fixing to a wallbox
The Revio wall station is intended to fit into a single gang
wallbox with a minimum internal depth of 2 in. (51 mm).
With the Revio wall station disassembled, use the two
supplied long screws to secure the rear chassis plate to
the wallbox.
Control wiring
The Revio wall station uses iCANnet connections to
ensure reliable and responsive transfer of control signals
between multiple devices.
Cable connections are made to a removable 5-way con-
nector block located at the rear of the Revio wall station
main body:
0V
CAN-L
(black)
(blue)
Cable type:
Maximum cable length:
Devices per segment:
* A maximum segment distance of 1000m/3200ft is possible if an
additional 12V power supply is used.
DRAIN
CAN-H
+12V
(gray)
(white)
(red)
Belden™ 1502P or similar
1000 ft. (305 m) *
100 (without bridge or repeater)
Advertisement
