Charging Your Reader; Installing A Microsd Card - Acer LumiRead 600 User Manual

Charging your reader

Before using your reader, you
must charge it for at least 30
minutes. After initial use you can
charge as needed.
Connect the USB cable to the
micro USB connector on your
reader, and then connect the USB
connector to the AC adapter. Plug
the AC adapter into an AC outlet
and charge the device.
It is normal for the reader to heat
up when charging or during long
periods of use. All Acer readers
are factory tested before release.

Installing a microSD card

To take expand your reader's capabilities, you may install a
microSD card. The card slot is located under a cover on the back
of the reader.
1. Open the card slot cover.
2. Orient the microSD card correctly and insert it into the slot.
Note: Ensure that the card is inserted all the way into the
card slot.
3. Close the card slot cover.
4. A micro SD icon will be displayed on the bookshelves.
See "The bookshelves" on page 13. Select and open
the icon to see the contents of the micro SD card.
9
,