Before The First Use - SmartLab Move User Manual

Before the first use

1. Remove the battery lash
To turn on the device, you need to remove the lash on the side of the device (pict 1). Please make sure that
your gateway is turned on.
Please remove the battery lash carefully. After removal the device will turn on. The three LEDs will light up
after each other several times for 5 seconds. Then the LED's will start blinking. This indicates that the device
is trying to communicate with the gateway to set the device.
pict 1
Notice: You will receive the needed gateway from your portal provider.
2. Mounting the carrying cord
You can wear your smartLAB move with the carrying cord included in the set. To do so, you will have to
®
connect the cord to the device by doing the following steps:
Push the thin end of the cord through the two tiny eyes at the back side of the device (pict 2). Pushing
together the cord a little bit makes it easier to squeeze it through them (pic. 3). After that, push the thicker
end of the cord through the loop on the thin end and pull it tight (pic. 4).
pict 2
pict 4
pict 3
Notice: The smartLAB® move is waterresitant and splashproof according to Norm IPX 4.