Miele KFN 14827 SDE ed/cs Operating And Installation Instructions page 72

Installing in a side-by-side combination
^ Push short trim m into the gap at the
top of the appliances. Make sure that
the front edge of the trim sits flush up
against the edge of connecting plate
c.
^ Fit cover n between the control
panels. Make sure that the outer
edges of the cover are flush with the
control panels. The cover can be
pulled out to adjust it to the right size.
^ Fit cover o to the bottom of the fronts
of the appliances.
72
^ Connect both appliances to the
electricity supply as described in the
operating instructions supplied with
the appliances.
^ Appliances with an ice cube maker:
Connect the appliance to the mains
water supply as described in the
operating instructions supplied with
it.
Warning. Risk of damage when
moving the appliances once they
have been joined together as they
are very heavy.
Moving them incorrectly can cause
dents. Carefully observe the
instructions on how to move the
appliances.
^ Carefully push the two appliances
back into their final position.
^ If necessary align the height of the
appliances again using outer feet b.
^ Unscrew middle feet c until they are
on the floor.
^ Support the appliance doors with foot
a on the hinge plate: Unscrew foot
a until it sits on the floor. Then
unscrew the foot by a further 90°.