Asus P5LP-LE User Manual page 19

2 . 2 . 2 . 2 . I D E c o n n e c t o r ( 4 0 - 1 p i n I D E ) I D E c o n n e c t o r ( 4 0 - 1 p i n I D E ) I D E c o n n e c t o r ( 4 0 - 1 p i n I D E )
2 . I D E c o n n e c t o r ( 4 0 - 1 p i n I D E ) I D E c o n n e c t o r ( 4 0 - 1 p i n I D E )
This connector is for an Ultra DMA 100/66 signal cable. The Ultra DMA
100/66 signal cable has three connectors: a blue connector for the primary
IDE connector on the motherboard, a black connector for an Ultra DMA
100/66 IDE slave device (optical drive/hard disk drive), and a gray
connector for an Ultra DMA 100/66 IDE master device (hard disk drive).
If you install two hard disk drives, you must configure the second drive as
a slave device by setting its jumper accordingly. Refer to the hard disk
documentation for the jumper settings.
• Pin 20 on the IDE connector is removed to match the covered hole on
the Ultra DMA cable connector. This prevents incorrect insertion when
you connect the IDE cable.
• Use the 40-conductor IDE cable for Ultra DMA IDE devices.
P5LP-LE (Emery2-UL8E)
IDE connector
A S U S P 5 L P - L E ( E m e r y 2 - U L 8 E ) A S U S P 5 L P - L E ( E m e r y 2 - U L 8 E )
A S U S P 5 L P - L E ( E m e r y 2 - U L 8 E ) A S U S P 5 L P - L E ( E m e r y 2 - U L 8 E ) A S U S P 5 L P - L E ( E m e r y 2 - U L 8 E )
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PIN 1
1 5 1 5
1 5 1 5 1 5