Samsung DW60H9970 Series User Manual page 19

Better washing results require the use of soft water.
Hard water contains impurities that can hinder the washing performance.
You will need to soften the water if the water supply is harder than 1.0 mmol/ℓ (6 °d – German scale).
To do this, you need:
• Dishwasher salt.
• Confi guration of the water hardness level according to your area.
For more information about the water hardness level in your area, contact your local water department.
If the hardness level of your water supply is unsteady, set the dishwasher to the highest measurement.
For example, if the water hardness reading ranges from 6.7 mmol/ℓ to 9.0 mmol/ℓ, set the dishwasher
to 9.0 mmol/ℓ.
The dishwasher's default water hardness level setting is 3 (4.0-5.5 mmol/ℓ). If this setting matches the water
hardness level in your area, there is no need to change it.
Brightness mode (Pocket LED brightness setting)
Press the Sanitize button until "B0 ~ B5" is displayed. (The higher numbers is more bright).
To change setting press Delay Start button. (for some models)
Auto Door mode
The door opens automatically when the cycle is complete to improve drying performace.
The door opens immediately before a cycle fi nishes, and "END" will appear on the display 30 seconds after
that.
Press the Sanitize button to enter Auto Door mode. ("AOn" on the display indicates Auto Door mode.)
Press the Delay Start button to enable or disable the Auto Door.
• AOn : Auto Door enabled.
• AOff : Auto Door disabled.
* Note that Auto Door will stay active throughout the ECO cycle with no option enabled.
* Once the door opens in Auto Door mode, the door cannot
be closed manually for the next 2 minutes.
* Auto Door will be disabled for the Quick cycle.
Changing "Auto Door mode" setting can infl uence drying result.
Select "AOn" mode for better drying result.
User Manual_DW9000H-Series-00156A_EN_140807.indd 19 User Manual_DW9000H-Series-00156A_EN_140807.indd 19
English - 19
2014-08-07 2014-08-07 5:26:18 5:26:18