Sleep Mode - ADC 6016 Instruction Manual

d) When the unit is set to the Average Mode setting, 3 separate
m e a s u rements will take place in succession followed by a calculation
of your detected blood pressure value. There will be 15 seconds of
resting time in-between each measure m e n t . A countdown indicates the
remaining time and a beep will sound 5 seconds before the 2nd and
3rd readings begin. If one of the measurements causes an error
message, it will be repeated one more time. If any additional errors
occur, the measurement will be discontinued and error code Err2 will
be displayed.
5.6. Discontinuing a measurement
If it is necessary to inter rupt a blood
pressure measurement for any reason
(e.g. the patient feels unwell), the 0/I
(ON/OFF) button can be pressed at any
time. The device then immediately lowers
the cuff pressure automatically and
enters into sleep mode.
5.7. Memory – storage and recall of the measurements
This blood pressure monitor automatically stores each of the last 30
measurement values per user. Be sure to select the desired user
(either User 1 or User 2) before accessing the stored measurements.
By pressing the MEMORY button, the last measurement (MR1) as
well as the last 29 measurements of that user (MR2, MR3,..., MR30)
can be displayed one after the other. (MR1: Values of the last
m e a s u rement. (MR2-MR30: Values of the measurements before MR1.)
19
Attention!
• After the battery warning appears, the device will not function until
the batteries have been replaced.
• Use "AAA" Long-Life or Alkaline 1.5V Batteries. The use of
rechargeable batteries is not recommended.
• If the blood pressure monitor is left unused for long periods,
remove the batteries from the device. NOTE: This will delete all
memory.
Functional check:
Press and hold the 0/I (ON/OFF) button to test all the display
elements. When the device is functioning correctly, all display
elements will be properly displayed.

4.2. Sleep mode

If this device is loaded with batteries, it will remain in sleep mode
when not in use (It will not turn off completely unless the batteries
are removed). In this mode, the time and user icon will be
displayed. You can conduct the following operations during this
mode.
• Reading the set date: Press the
TIME buttton. The date set will be
displayed for 2 seconds.For more
information, refer to Section 4.3.
• Recalling the measurements: Press
the MEMORY button. The stored
measurements will be displayed. For
more information, refer to Section 5.7.
• Printing the measured data: Press
the PRINT button. The stored
measurement can be printed. For
more information, refer to Section 6.
12