Download Print this page

Sheffield BI-150 Instruction Manual

Download this manual

Profissional

Blender

BT-150

BI-150

36121.6-JULHO/2009

Need help?

Do you have a question about the BI-150 and is the answer not in the manual?

Page 1 Profissional Blender BT-150 BI-150 36121.6-JULHO/2009...
Page 2 Tabla - 02 SUMMARY Problemas Causas Soluciones Check if plug is Electricity shortage or * Machine does not starts. 1. Introduction c o n n e c t t o p o w e r machine is unplugged. 1.1 Safety source.
Page 3 1.1.19 Never throw water or other liquid substances directly to the machine. 1.1.20 Never connect power source with wet feet or wet clothes. 5.1 Problems, Causes and Solutions The BI-150 and BT-150 Professional Blender were designed to need very little maintenance. However, some irregularities may occur due to the natural wearing.
Page 4 1.3 Technical Characteristics circuits. Tabla - 01 Oil reservoir has to be full up to the required level as indicated. Check level and BT-150 BI-150 add oil if necessary. CHARACTERÍSTICS U.M. 110 ou 220 * 110 ou 220 * Voltage...
Page 5: General Safety Practices
The machine has to be delivered only in The blender BI-150 and BT-150 must be installed on a leveled surface with a perfect conditions of use by the Distributor to the user. The user shall operate the machine recommended height of 850mm.
Page 6 3 - OPERATION CLEANING 3.1 – To start machine The cup parts are resistant to corrosion, are hygienic and easily cleaned. Before using them for the first time and after each use, separate Start machine by turning ON/OFF Switch No. 05 to position ON, the them (Pic.01) and clean them with warm water and soap, wipe and dry them Switch is located on the motor housing.

Bt-150