Table of Contents
Advertisement
Installation
In the next box, you can specify the search locations to reduce the searching
time. Check " Floppy disk drives" if you have the driver on a floppy disk, or "CD
ROM drives" if you have it on s CD-ROM. Hit Enter to activate the Next button.
Finally, confirm that you want to install the "BRAILLEX.INF" driver that Windows
found on the media you specified and hit Enter to activate the Next button.
The next box confirms that you have installed a "Papenmeier Braillex II USB
device". Hit Enter to activate the Finish button.
Serial Connection
In case you want to connect BRAILLEX EL 80s via serial port, you have to use
the supplied power supply. No further installation is required (besides the screen
reader software, see below).
Start Message
As soon as the display unit is powered on (see above), you will see a start
message:
"BRAILLEX EL 80s" and the revision number of the actual firmware of the device.
Installing the Screen reader
If you want to read the computer screen on the Braille display, you need to
install and run a screen reader package. Depending on the package you might
need to install driver software for the BRAILLEX EL 80s.
4
Advertisement
Table of Contents
