Presser Bar Height And Alignment - Janome MC7700 QCP Service Manual

PRESSER BAR HEIGHT AND ALIGNMENT (1)

WHEN THE PRESSER FOOT IS LIFTED, THE DISTANCE BETWEEN THE SURFACE OF THE NEEDLE PLATE AND
THE BOTTOM OF THE ZIGZAG FOOT SHOULD BE 6 MM.
SETSCREW (A)
NEEDLE BAR
SUPPORTER
SPRING
SETSCREW E
SETSCREW (D)
SETSCREW (C)
SETSCREW (G)
MECHANICAL ADJUSTMENT
LED LAMP
SETSCREW B
CARRYING
HANDLE
SUPPORTER
FRONT
BRACKET
SETSCREW (F)
1. ATTACH THE ZIGZAG FOOT A.
ADJUST THE PRESSER FOOT PRESSURE DIAL
TO "7".
REMOVE THE TOP COVER.
(SEE PAGE 1)
2. RAISE THE PRESSER FOOT LIFTER.
3. LOWER THE FEED DOG.
4. REMOVE THE NEEDLE BAR SUPPORTER
SPRING.
5. REMOVE THE SETSCREW (A) AND REMOVE THE
LED LAMP.
6. REMOVE THE SETSCREWS (B), (C) AND (D).
REMOVE THE CARRYING HANDLE
SUPPORTER.
7. REMOVE THE SETSCREWS (E), (F) AND (G).
REMOVE THE FRONT BRACKET.
8