Code Alarm ROG1 Owner's Manual page 5

System Functions
To enter valet mode:
With the key, turn the ignition on, then turn off 3 times within 5 seconds.
To exit Valet mode:
With the key, turn the ignition on, then turn off 3 times within 5 seconds.
When Your Security System is Triggered
The uipgrade security system will trigger if one of the following events
occurs while the system is armed:
• Any protected entrance is opened
• The vehicle ignition is turned on
• The vehicle is jolted hard enough to signal the impact detector
Once the alarm is triggered, the siren (or horn) sounds and the
vehicle parking lights flash for 30 seconds. The system will then re-
arm, awaiting the next intrusion attempt. To stop the siren while
keeping the alarm armed and doors locked: press the LOCK button
(on the Keyless Entry Remote) while the system is triggered.
The Interior Status Indicator
The Status Indicator is a high-intensity red light mounted in a visible
location on the vehicle dashboard. This red light gives a visual
indication of the alarm system's state of operation. Note the chart below:
If the Status Indicator is...
Off
Flashing Slowly
Flashing Very Quickly
Flashing Intermittently
(2 flashes, off, 2 flashes)
On (not flashing)
(cont.)
....then the Security System
is disarmed
is armed
was triggered in your absence
(see Attempted Intrusion ID - page 4)
is in Valet mode
is in Pre-arm mode
5