Warning; Important; Fitting A Different Plug - Blomberg GSN 9121 Instruction Manual

Warning

This appliance must be earthed
If the fitted moulded plug is not suitable for
your socket, then the plug should be cut
off and an appropriate plug fitted.
Destroy the old plug, which is cut off as
a plug with a bared cord could cause a
shock hazard if inserted into a socket
elsewhere in the house.
The moulded plug on this appliance
incorporates a 13A fuse. Should the fuse
need to be replaced an ASTA approved
BS1362 fuse of the same rating must be
used. Do not forget to refit the fuse cover.
In the event of losing the fuse cover, the
plug must not be used until a replacement
fuse cover has been fitted. Colour of the
replacement fuse cover must be the same
colour as that visible on the pin face of the
plug. Fuse covers are available from any
good electrical store.

Important

Fitting a different plug

As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying
the terminals on your plug, proceed as
follows:
1. Connect the green - yellow or green
(earth) wire to the terminal in the plug
marked 'E' or with the symbol
coloured green and yellow or green.
2. Connect the blue (neutral) wire to
the terminal in the plug marked 'N' or
coloured black.
3. Connect the brown (live) wire to the
terminal in the plug marked 'L' or
coloured red.
With the alternative plugs a 13A fuse must
be fitted either in the plug or adaptor or
in the main fuse box. If in doubt contact a
qualified electrician.
����������������
�
�������
�����
AQUASAFE+
The Aquasafe+ System protects
against water damage which may be
caused at the water inlet hose.
Do not immerse the system's valve
box into water; it contains electrical
components.
In case of damage, pull out the power
supply plug.
Do not shorten or lengthen the hose
insert as it contains electrical cables
or
and components.
����
10 GB
��������
������������
������
���������
�