Using The Chime Alarm - Radio Shack 65562 Owner's Manual

49-329.fm Page 22 Thursday, June 1, 2000 7:46 AM
Notes:
• You can temporarily silence the alarm only once
each time you disarm it.
• If entering your security code does not disarm
the sensor alarm, try entering the default code
(1234). If that code does not disarm the alarm
either, remove the sensor alarm from the wall
and remove and reinstall the batteries. This
resets the security code to 1234.

USING THE CHIME ALARM

If you prefer to hear a chime instead of a siren when
the sensor alarm detects motion, follow these steps.
1. If necessary, disarm the sensor alarm (the red
indicator should not be flashing) by entering the
current security code.
2. Set the slide switch on the main unit to
doorbell-type chime immediately sounds.
3. When the sensor detects any motion, the chime
sounds again.
Note: There is no need to arm or disarm the alarm
when using the
CHIME
22
Operation
CHIME
setting because the chime
. A