THUNDER TIGER Fun Tiger Extra Assembly Instructions Manual page 15

LINKAGE
You will need to drill a 3/16" hole through
the balsa webbing on the inside of the wing
to allow the inner nyrod to reach the servo.
Use the servo itself and the outer nyrod you
just slipped into place to determine the loca-
tion.
Next, thread one of the studs furnished
into one of the inner nyrods for about 3/8".
Screw a clevis onto this stud for about 3/8".
From the inside of the wing out, slip the inner
rod into the outer rod and hook the clevis up
to the servo arm. NOTE: a small screw-
driver inserted between the forks of the cle-
vis and carefully rotated will spread the forks
for installation. Route the nyrod down the
fuselage to the tail. The other end of this
nyrod will link to the elevator via a control
horn.
11