Sony D-EJ855 Service Manual page 34

D-EJ855
• DIAGRAM
NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
Note on Printed Wiring Board
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
• : Through hole.
z
• : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from
(Conductor Side) the pattern face are indicated.
Parts face side: Parts on the parts face side seen from
(Component Side) the parts face are indicated.
• MAIN board is multi-layer printed board. However, the patterns
of intermediate-layer have not been included in the diagram.
2
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1 / W or less unless otherwise
4
specified.
• % : indicates tolerance.
• C : panel designation.
Note:
Note:
Les composants identifiés par
The components identi-
une marque 0 sont critiques
fied by mark 0 or dotted
line with mark 0 are criti-
pour la sécurité.
Ne les remplacer que par une
cal for safety.
pièce por tant le numéro
Replace only with part
spécifié.
number specified.
• A : B+ Line.
• Power voltage is dc 4.5 V and fed with regulated dc power
supply from DC IN jack (J401).
• Voltages and waveforms are dc with respect to ground in
no-signal conditions.
no mark : CD PLAY
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
J
: CD PLAY (ANALOG OUT)
c : CD PLAY (OPTICAL OUT)
• Abbreviation
FR: French model