Electronic Article Surveillance (Eas) (Optional); Connecting To A Host - Symbol LS 6000 Series Product Reference Manual

Electronic Article Surveillance (EAS)
(Optional)
Because there are several Checkpoint EAS systems available,
your local Checkpoint representative must install the EAS cable.
To contact your local Checkpoint representative inside the U.S.
call 800-257-5540, ext. 4300. Outside the U.S., call (609) 848-
1800, ext. 4300.
If you are using an EAS cable, refer to the Universal Cable EAS
Installation Sheet (Symbol p/n 70-32824-XX).

Connecting to a Host

Following are detailed instructions for connecting the LS 6000
to your host.
1. Power down the host terminal.
2. Connect the interface cable to the host terminal (refer to
your terminal manual to locate the correct port).
3. If necessary, plug the power supply into the power jack
on the interface cable. Depending on the cable, this is
located either on the cable's connector itself, or on a
"lump" on the cable.
4. Plug the other end of the power supply into an AC
outlet.
Setup
2-3