Advertisement
LOCATION OF THE SB-175 UNIT
1.) The most desirable place to install the unit is on the main water line that enters the house.
2.) The power unit should be mounted on a wall or other solid surface within five feet from an electrical
outlet and within ten feet from where the pipe will be wrapped.
3.) Once the main water inlet pipe to the house is located, identify a section of pipe that is at least 12
inches straight and at least two feet away from any major electrical interference, example - an
electric motor.
Installs on the incoming water supply line
SB-175 comes with a
5 foot power cord.
water going to house
Important! For best results, wrap signal cable on a
straight section of pipe of 12" or more. Keep the
signal cable as far away as possible from tees,
elbows, couplings, valves and any curved pipe.
At least 12 inches of straight pipe
4
main water
shutoff valve
Keep signal cable at
least
two feet
away
from any major
electrical interference.
No more than
ten feet
of wire is allowed
between the power box
terminals and the
signal cable location
wrapped on the pipe.
Keep wires from
touching each other -
going from the
terminals to the signal
cable location on the
pipe.
Install the signal cable
on the incoming cold
water supply line
entering the home as
close to where it comes
into the house as
possible.
Advertisement
