Page 1
CD CHANGER SYSTEM This Service Manual contains the additional information "SERVICE JIG AND TOOLS", TEST MODE and VOLTAGE for the model ADC-V107(YH). If requiring the other information, see Service Manual of ADC-V107(YH), (S/M Code No. 09-008-404-5R8). S/M Code No. 09-009-404-5S3...
SERVICE JIG AND TOOLS 1. FFC connector removal Lift the connector lock upward at an angle of 90 degree to remove the FFC connector. > 2. How to use repairing jig For repair, use the jig kit specified as follows. Parts Name Parts Number 10-roll use...
Page 3
5. Parts installation 1) Solder the attached Transistor onto the previously removed Q301 of P.W.B.MAIN. 6. Board wiring 1) Solder MOTOR wire and Sensor (PD701) wire, removed at Step 3, onto P.W.B. JIG. (fig-2) 2) Solder wires from P.W.B. JIG onto respective land. (fig-3) •...
Page 4
SCHEMATIC DIAGRAM -1 (SERVO : 1 / 2) << VOLTAGE INFORMATION >> 4 ...
Page 5
SCHEMATIC DIAGRAM - 2 (SERVO : 2 / 2 / JACK / SENSOR / FLEX JACK ) << VOLTAGE INFORMATION >> 5 ...
Page 6
SCHEMATIC DIAGRAM - 3 (MPEG / JACK / FLEX JACK) << VOLTAGE INFORMATION >> 6 ...
TEST MODE 1) How to activate CD test mode 1) Press and hold the STOP button of P.W.B. Key and connect +12V to ACC/BACK UP. 2) How to cancel CD test mode 1) Disconnect +12V to ACC/BACK UP. 3) CD test mode functions See fig-11 for the details of P.W.B.
Page 8
211, IKENOHATA 1CHOME, TAITO-KU, TOKYO 110, JAPAN TEL:03 (3827) 3111 2000058 Printed in Singapore...