Advertisement
SERVICE JIG AND TOOLS
1. FFC connector removal
Lift the connector lock upward at an angle of 90 degree to remove the FFC connector.
2. How to use repairing jig
For repair, use the jig kit specified as follows.
The kit includes the following 5 tools.
1. FFC (26P/25cm)
2. P.W.B. FLEX
3. P.W.B. JIG
4. TRANSISTOR (2SD2395)
5. P.W.B. KEY
1. Using jig
1. CABI BOTTOM removal
1) Remove the CABI BOTTOM.
2. P.W.B. VIDEO removal (fig-1)
1) Remove the screws and release the hooks, and then take out P.W.B. VIDEO. 2 hooks
2) Remove the PWB FLEX from the main unit.
3. P.W.B. MAIN removal
1) Remove the soldered parts from each terminal of Transistor Q301 (2SD2395).
2) Remove the 2 motor wires (BLU/WHT).SD
3) Remove the 2 wires (BLK/BRN) from P.W.B. Sensor (PD701).
4) Remove the P.W.B. MAIN from the main unit.
5) Remove the LED (LED701) from P.W.B. MAIN.
6) Remove the Sensor (PS701)
from P.W.B. MAIN.
4. Jig assembly
1) Attach P.W.B. JIG to the unit with screws. (fig-2)
>
Parts Name
10-roll use
JIG-ADC-EX106
1pcs
1pcs
1pcs
1pcs
1pcs
Parts Number
SV-J00-090-010
VTT+2.6-6 B
4 pcs
VT+2.6-4B
2 pcs
U+2.6-4
3 pcs
U+3-10
1 pcs
V+2-3
2 pcs
V+2-4
2 pcs
HLD P.W.B
2 pcs
GL380
SENR GP1S94
– 2 –
fig-1
fig-2
Advertisement
