Removing The Memory Module; Installing The Memory Module - Lenovo ThinkCentre 9349 Hardware Installation Manual

This section provides instructions on how to replace a memory module.
Note: Your computer has support for two memory modules.
1. Remove the computer cover. See "Removing the cover" on page 12.
Note: For this procedure, it helps to lay the computer on its side.
2. Locate the memory connectors. See "Identifying parts on the system board" on
page 9.
3. Remove the memory module being replaced by opening the retaining clips as
shown.
Figure 32. Removing the memory module
4. Position the replacement memory module over the memory connector. Make
sure the notch 1 on the memory module aligns correctly with the connector
key 2 on the system board. Push the memory module straight down into the
connector until the retaining clips close.
Figure 33. Installing the memory module
5. Go to Chapter 4, "Completing the parts replacement," on page 47.
Chapter 3. Installing options and replacing hardware
37