Polaris 3900 Sport Owner's Manual page 5

3
Assemble the Cleaner
1. A ttach the feed hose connector
to the feed pipe by pressing it
down firmly until it locks.
2. The filter bag is packaged in
the collar area on the vacuum
tube. Pull out bag. Wrap bag
around hose and secure with
Velcro strips.
3. T urn on the pool filtration pump
and allow it to prime before
turning on the booster pump.
4
Check for Proper RPM
Before operating the Polaris
proper wheel revolutions per minute (RPM).
For maximum efficiency, the cleaner should
operate between 30 and 36 RPM.
1. Mark the single-wheel
side tire.
2. Turn pump on, hold cleaner
below water level and count
wheel revolutions for one minute.
If count is not in target range,
refer to Adjusting the Wheel RPM
in the Troubleshooting section for
more information.
, check for
®
Single-wheel Side
5
Hose
Sweep Hose
Bag
Feed Hose
Connector
Feed
Pipe