Table of Contents
Advertisement
• 2 brackets
1.
Place the ESD mat on the floor where you will be working and put on the ESD strap. Make
sure the ESD strap is touching your skin and that the other end is connected to a verified
ground.
Rail
Bracket
Rail slide
Before you install your new gateway, unpack the system and check to make sure that all the parts
have been sent, check this against the parts list. Check the parts for visible damages that may have
occurred during shipping.
If anything is damaged or missing, contact your customer representative immediately.
2.
Screw the brackets onto the gateway. Use 3or 4 (depending on the bracket position) flat head
screws to connect each bracket to the gateway.
If you need room to bring the power cord from the other side of the rack, recess
the gateway and run the power cord through the bracket.The installation kit
can be reversed so that the bracket can be installed on either side of the gate-
way the power side or the connector (IB/ETH) side.
• 8 pan head screws M6
Figure 14: Installation Kit Parts
Mellanox Technologies
Rev 1.4
27
Advertisement
Table of Contents
