Status Indicator Lights; Delay Start; Status Window - Kenmore 587.1529 series Use & Care Manual

Operating Instructions
Child Lock Controls
To preven children from accidently changing
the dishwasher cycle or starting the
dishwasher, lock the dishwasher controls by
pressing and releasing the DELAY START pad
for 3 seconds. An indicator light on the lock
graphic pad will illuminate when the controls
are locked and no new selections can be
made until the lock released. To unlock the
controls, press the DELAY START pad until the
indicator light goes out.

Delay Start

The DELAY START option allows you to
automatically delay starting your dishwasher
from 1-24 hours.
On models with 1-24 hour delay, press the
DELAY START pad until the desired delay time
shows in the STATUS window. A light will com
on indicating the delay start hours and will
remain on until cycle starts.
To cancel the DELAY START option and begin
the cycle before the delay period is over, press
the START/CANCEL pad.

Status Window

Minutes.................
PF............................
Note: The time remaing could suddenly increase or drop several minutes. This means the iSense
Soil Sensor has checked the soil level and determined if additional water fi lls are needed or if
water fi lls can be deleted.
Number of minutes left
in cycle (1-99). If cycle
is longer that 99 minutes
a small light will appear
in the lower right corner
and remain on until time
counts below 99.
Appears in window
when dishwasher is fi rst
installed, or when power
has been interrupted. HI
TEMP WASH and NO
HEAT DRY indicator
lights will also fl ash. To
clear, touch START/
CANCEL pad.

Status Indicator Lights

The WASHING light comes on at the beginning
of cycle and remains on until the end of the
main wash.
Whether heated or unheated dry is selected the
DRYING light will come on during the drying
portion of the cycle.
When the SANITIZE option is selected, the
SANITIZED light will glow when the SANITIZE
cycle is fi nished and remain on until the door
is opened. If the dishwasher did not properly
sanitize the dishes, the light will not come on.
This can happen if the cycle is interrupted or
if incoming water temperature is below 120
The light will remain on until the door is opened.
The CLEAN light will come on at end of cycle
and remain on until door is opened.
In the unlikely event the dishwasher
malfunctions, the indicator may display one of
the following codes "Er", "uF", "uo", or "CE". If
one of these codes are displayed contact the
Kenmore Customer Care Center at 1-800-4MY-
HOME. They will be able to provide assistance
in troubleshooting the problem and/or locating
an authorized service technician, if needed.
delay
clean
s
washing
drying
Sanitize Indicator
1H-24H..................
CL..........................
Hd or HO.............
LO..........................
11
Number of delay start
hours. The last hour will
count down in minutes.
Close dishwasher door.
The status indicator
lights will also fl ash to
indicate current cycle
status.
Indicates a water heat
delay.
Appears in window
when the rinse aid
dispenser is low and
needs to be refi lled.
0 F..