Setting, Changing, And Deleting A Password; Using Security Profile By Device; Selecting A Startup Device - Lenovo 8097 User Manual

Lenovo user guide desktop pc 8097, 8143, 8144, 8146, 8422, 8423, 8427
Table of Contents

Advertisement

If both the IDE Drive User Password and the IDE Drive Master Password are to be
set, the IDE Drive Master Password must be set before setting the IDE Drive User
Password.

Setting, changing, and deleting a password

To set, change, or delete a password, do the following:
Note: A password can be any combination of up to seven characters (A- Z, a-z,
1. Start the Setup Utility program (see "Starting the Setup Utility program" on
2. From the Setup Utility program menu, select Security.
3. Select Set Passwords. Read the information displayed on the right side of the

Using Security Profile by Device

Security Profile by Device is used to enable or disable user access to the following
devices:
IDE controller
Diskette Drive Access
Diskette Write Protect
To set Security Profile by Device, do the following:
1. Start the Setup Utility program (see "Starting the Setup Utility program" on
2. From the Setup Utility program menu, select Security.
3. Select Security Profile by Device.
4. Select the desired devices and settings and press Enter.
5. Return to the Setup Utility program menu and select Exit and then Save

Selecting a startup device

If your computer does not start up (boot) from a device such as the CD-ROM,
diskette, or hard disk as expected, use one of the following procedures to select a
startup device.
Attention
Make sure that the IDE Drive Master password is stored in a safe place. If
both the IDE Drive User password and the IDE Drive Master password are
lost or forgotten, the IDE hard disk drive must be replaced.
and 0-9).
page 25).
screen.
When this feature is set to Disable, all devices connected to the
IDE controller (such as hard disk drives or the CD-ROM drive)
are disabled and will not be displayed in the system
configuration.
When this feature is set to Disable, the diskette drive cannot be
accessed.
When this feature is set to Enable, all diskettes are treated as if
they are write-protected. You can read from the diskette, but you
cannot write to the diskette.
page 25).
Settings.
Chapter 2. Using the Setup Utility program
27

Advertisement

Table of Contents
loading

This manual is also suitable for:

814381448146842284238427 ... Show all

Table of Contents