Replacing The Cover And Connecting The Cables - Lenovo 6491 User Manual

6. Restart the computer, leave it on for approximately ten seconds. Turn off the
7. Repeat steps 1 through 3 on page 38.
8. Move the Clear CMOS/Recovery jumper back to the standard position (pins 1
9. Replace the computer cover and connect the power cord. See "Replacing the

Replacing the cover and connecting the cables

After working with options, you need to install any removed parts, close the
computer cover, and reconnect cables, including telephone lines and power cords.
Also, depending on the option that is installed, you might need to confirm the
updated information in the Setup Utility program.
To replace the computer cover and connect cables to your computer:
1. Ensure that all components have been reassembled correctly and that no tools
2. Reposition any cables that might impede the replacement of the computer
3. Align the drive bay assembly with the two slots and rails on the sides of the
4. Reinstall the front bezel if it was removed.
computer by holding the power switch for approximately five seconds. The
computer will turn off.
and 2).
cover and connecting the cables."
or loose screws are left inside your computer.
cover.
Important
Correctly route all power supply cables to avoid interference with the
drive bay assembly. Keep cables clear of the hinges and sides of the
computer chassis.
chassis, reconnect the drive cables on the system board, and then slide the
drive bay assembly towards the rear of the chassis until it snaps into position.
Chapter 3. Installing options
39