Lithium Battery Notice; Modem Safety Information - Lenovo 6491 User Manual

Lenovo user guide desktop pc 6491, 8013, 8702, 8706 types 8716, 8970, 8972, 8976, 8980, 8982, 8986, 8992, 8994, 9266, 9276, 9278, 9282, 9286, 9288, 9374, 9378, 9380, 9384, 9628, 9632, 9647, 9649, 9695
Table of Contents

Advertisement

Lithium battery notice

When replacing the lithium coin cell battery, use only the same or an equivalent
type that is recommended by the manufacturer. The battery contains lithium and
can explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
The following statement applies to users in the state of California, U.S.A.
Perchlorate material: Special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate.

Modem safety information

To reduce the risk of fire, electrical shock, or injury when using telephone
equipment, always follow basic safety precautions, such as:
v Never install telephone wiring during a lightning storm.
v Never install telephone jacks in wet locations unless the jack is specifically
v Never touch uninsulated telephone wires or terminals unless the telephone line
v Use caution when installing or modifying telephone lines.
v Avoid using a telephone (other than a cordless type) during an electrical storm.
v Do not use the telephone to report a gas leak in the vicinity of the leak.
xii
User Guide
To connect:
1. Turn everything OFF.
2. First, attach all cables to devices.
3. Attach signal cables to connectors.
4. Attach power cords to outlet.
5. Turn device ON.
Caution
Danger of explosion if battery is incorrectly replaced.
Caution
To reduce the risk of fire, use only No. 26 AWG or larger
telecommunication line cord.
designed for wet locations.
has been disconnected at the network interface.
There may be a remote risk of electric shock from lightning.
To disconnect:
1. Turn everything OFF.
2. First, remove power cords from outlet.
3. Remove signal cables from connectors.
4. Remove all cables from devices.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents