Lenovo ThinkPad Z61e Troubleshooting Manual page 21
Lenovo thinkpad notebook pc models z61e, z61m, z61t service and troubleshooting guide
Hide thumbs
Also See for ThinkPad Z61e:
- Hardware maintenance manual (178 pages) ,
- Service and troubleshooting manual (94 pages) ,
- Dizüstü bilgisayar tanıtma ve kullanma kılavuzu (88 pages)
Table of Contents
Advertisement
Message:
0176: System Security - The System has been tampered with.
Solution:
This message is displayed if you remove the Security Chip and reinstall it, or install a
new one. To clear the error, enter the BIOS Setup Utility, press F9 to set values to
default, then press F10 to save changes. If this does not solve the problem, have the
computer serviced.
Message:
0182: Bad CRC2. Enter BIOS Setup and load Setup defaults.
Solution:
Checksum of the CRC2 setting in the EEPROM is not correct. Press F1 to go to BIOS
Setup Utility. Press F9 and then Enter to load the default setting. Press F10 and then
Enter to restart the system.
Message:
0185: Bad startup sequence settings. Enter BIOS Setup and load Setup defaults.
Solution:
Checksum of the startup sequence setting in the EEPROM is not correct. Press F1 to go
to BIOS Setup Utility. Press F9 and then Enter to load the default setting. Press F10
and then Enter to restart the system.
0190: Critical low-battery error
Message:
The computer turned off because the battery is low. Connect the ac adapter to the
Solution:
computer and charge the battery, or replace the battery with a fully charged one.
Message:
0191: System Security - Invalid remote change requested.
Solution:
The system configuration change has failed. Confirm the operation and try again.To
clear the error, enter the BIOS Setup Utility, press F9 to set values to default then press
F10 to save changes.
Message:
0199: System Security - Security password retry count exceeded.
Solution:
This message is displayed if you enter a wrong supervisor password more than three
times. Confirm the supervisor password and try again. To clear the error, enter the
BIOS Setup Utility.
Message:
01C8: More than one modem devices are found. Remove one of them. Press <Esc> to
continue.
Solution:
Remove either a Modem Mini-PCI Card or a Modem Daughter Cards. Otherwise,
press Esc to ignore the warning message. If it does not solve this problem, have the
computer serviced.
Solving computer problems
Chapter 3. Solving computer problems
13
Advertisement
Table of Contents
