Assembly Instructions - Yedoo OX User Manual

EN

ASSEMBLY INSTRUCTIONS

1. 2.
Assembly of the front (bigger) Make sure the front fork of the
wheel: loosen both nuts.
scooter is well positioned (brake
levers are facing forward). Release
the brake cable from its holder
and loosen the brake arms.
7. 8.
Assembly of the rear wheel is Installation of brake cables:
the same as the assembly of the press the brake lever to the maxi-
front wheel. Loosen both nuts, mum and insert the ending of the
release the brake cable from its brake cable into the circular fixing
holder and loosen the brake arms. point. Repeat the action with
Then place the wheel into the both brakes.
rear front fork so that is well-cen-
tred, tighten both nuts and return
the right, front brake cable on the left.
the brake cable into the holder.
18
3.
Place the wheel into the front fork
so that is well-centred.
The tread pattern (arrow-shaped lines
on the tires) must be pointing to the front.
9.
Adjustment of brake levers:
incline the brake levers correctly
by loosening the screw on the
sleeve.
The right inclination: stand on the
footboard, hold the handles and stretch
out your fingers in a way that your arm and
The rear brake cable is usually fixed on
the fingers form a single straight line. This
should be the position of the brake levers.
4. 5.
Handlebar installation: place
Tighten both nuts and return the
brake cable into the holder. the handlebar tube as shown
on the picture and tighten the
screws on the stem.
10. 11.
1
Adjustment of brakes: when Check that the pads make enough
braking, check that the brake space (1–2 mm) after releasing
pads of both wheels fit tightly on the brake levers. The distance
the rim sides. If not, you can ad- can be adjusted by tightening or
just their position via a screw that loosening the brake cable at the
connects them to the V-brake anchor screw (2).
arms (1). The pads shall not touch
the tire.
6.
1
2
Insert the handlebar tube into
the front frame (1) and adjust
the height according to the
rider's needs (not higher than
indicated by the line). Check that
the handlebar is upright and
properly tighten the screw on the
handlebar tube (2).
12.
2
3
In case the brake pad is touching
the wheel when turning, symmet-
rically adjust the distance of brake
arms by the tightening screws (3).
19