Drum Lighting; Before Using For The First Time - Miele T 8164 WP Operating Instructions Manual

Display h min
The display shows:
– the programme duration (h min =
hours and minutes)
– Check and fault messages
– Settings
The settings are used to tailor the
dryer's electronics to suit your indi‐
vidual requirements.
See "Settings" for more information.
Estimated time remaining
After the start of a programme the esti‐
mated programme duration will appear
in the h min display in hours and mi‐
nutes (estimated time remaining). The
only exception to this are the Timed
drying programmes which last for 20
minutes.
The estimated duration (time remaining)
will appear in the display. The following
factors all affect the estimated time re‐
maining: residual moisture content after
spinning; type of fabric; size of load;
room temperature; fluctuations in power
supply. The electronics continually as‐
sess conditions in the appliance and
adjust the estimated time remaining for
a more accurate reading. Because of
this, the time displayed can alter during
the course of a programme. Pro‐
grammes can also finish earlier than ex‐
pected, if, for example, particularly fine
fabric is being dried, the load is very
small or items were partially dry before‐
hand.
Operating the tumble dryer

Drum lighting

If the dryer is switched on at the mains
and the door is opened, the drum light‐
ing will come on. It will go out a few mi‐
nutes later to save energy.

Before using for the first time


Ensure that the dryer is installed
and connected to the electricity sup‐
ply correctly. If the tumble dryer has
not been transported as described in
"Installation and connection" then it
must be left to stand for at least 1
hour before it is connected to the
electricity supply.
17