Table of Contents
Advertisement
CMO Operations & Logistics
Training and Vendor Development
Multimedia Creation & Support
11.
UPPER BLOCK - HINGE MODULE DISASSEMBLY
1. The procedure to disassemble the Hinge Module Assy is
shown here. The disassembly of the lower block was already
done.
3. Undo both screws and discard them.
5. Carefully remove the Camera Support.
Service Manual N92 RM-100
Page
20
(53)
CONFIDENTIAL
2. Carefully pull out the cables to achieve the screws.
4. Do not use them again.
6. Slot the Camera Cable through the recess of the hinge.
Copyright © 2006 NOKIA Corporation. All rights reserved.
Approved 1.0
MGR
17.Okt.2006
Advertisement
Table of Contents
