Advertisement
-5-
b.
A face seal is rncunted in the resilient
bearing
and the courterface
is rmunted
on the spin can shaft.
Ttris seal is to
prevent water leakge.
If the face seal
is replaced,
the c<,unterface nust be
replaced also.
Rernove the two bolts
which secure the rubber nnunt
to the frame and renpve the spin pulley
assembly.
To replace the rubber nount assembly, rennve the
three scre$/s fr"qn the retaining
ring and the rubber
rnrunt with bearing can be rernoved fron the pulley.
In replacenent,
the bolt
in the spin pulley which
secures the spin can shaft nn:st be tight.
If not,
the spin can shaft will
revolve
in the spin pulley
causing noise and wear.
w r .
SPINNM ALIANI.,INM ADruS'IIUEM
1.
Block machine up off the floor,
V€t still
level.
2.
Rernove the spin belt.
3.
Ioosen the bolts
securing the nrbber nrcunt to the
frarne so the nrbber mount can be rxlved - yet snug
enough so that
it will
stay in the position
placed.
4.
Move the nrbber rnnrnt so that the top of the spin
can is *" off
center toward the rear of the mactrine.
5.
Tighten the bolts
to the frame and install
the spin
belt"
Ttre proper belt
tension will
draw the spin
can back to center.
If the spin can does not go back to center,
the belt
is too loose.
If the spin can goes too far out of center,
the belt
is too tight.
Adjust spin rnrtor for proper belt
tension - Paragraph
V I I I .
T . F . 2 6 - 2 2
5 .
6 .
7 .
Advertisement
