Lenovo THINKCENTRE 3317 Hardware Maintenance Manual page 52

Diagnostic error code
001-038-XXX System Extension failure
001-039-XXX System DMI data structure error
001-040-XXX System IRQ failure
001-041-XXX System DMA failure
001-195-XXX System Test aborted by user
001-196-XXX System test halt, error threshold exceeded
001-197-XXX System test warning
001-198-XXX System test aborted
001-199-XXX System test failed, cause unknown
001-250-XXX System ECC error
001-254-XXX 001-255-XXX 001-256-XXX 001-257-XXX
System DMA error
001-260-XXX 001-264-XXX System IRQ error
001-268-XXX System IRQ1 failure
001-269-XXX System IRQ2 failure
001-270-XXX System IRQ3 failure
001-271-XXX System IRQ4 failure
001-272-XXX System IRQ5 failure
46
ThinkCentre Hardware Maintenance Manual
FRU/Action
1. Adapter card
2. System board
1. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 203
2. System board
1. Power-off/on system and re-test
2. System board
1. Power-off/on system and re-test
2. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using
the Setup Utility program" on page 39
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 "Using
the Setup Utility program" on page 39
2. Flash the system and retest. See "Updating (flashing)
BIOS from a disc" on page 203
3. Go to "Undetermined problems" on page 65
1. Go to "Undetermined problems" on page 65
2. Flash the system and re-test
3. Replace component under function test
System board
System board
System board
1. Device on IRQ1
2. System board
1. Device on IRQ2
2. System board
1. Device on IRQ3
2. System board
1. Device on IRQ4
2. System board
1. Device on IRQ5
2. System board