Completing The Fru Replacement - Lenovo THINKCENTRE 3317 Hardware Maintenance Manual

Completing the FRU replacement

This section provides instructions on how to complete the FRU replacement.
After replacing the FRUs, you need to reinstall any removed parts, reconnect and route any internal cables,
reinstall the computer cover, and reconnect any external cables, such as power cords. Depending on the
FRUs replaced, you might need to confirm the updated information in the Setup Utility program, see Chapter
6 "Using the Setup Utility program" on page 39.
Note: When the power cord is first plugged in, the computer might appear to turn on for a few seconds and
then turn off. This is a normal sequence to enable the computer to initialize.
To reinstall the computer cover and reconnect cables to your computer:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are
left inside your computer. See "Locating components" on page 69 for the location of the various
components.
2. Reconnect any internal cables.
3. Position the computer cover on the chassis so that the rail guides on the bottom of the computer cover
engage the rails. Then, push the computer cover closed until it snaps into position.
Figure 37. Reinstalling the computer cover
4. If the computer cover is secured with thumbscrews, install them.
5. If a cover lock is installed, lock the cover.
6. Reconnect the external cables and power cords to the computer. See "Locating connectors on the
rear of your computer" on page 67.
7. If you have replaced the system board, you must update (flash) the BIOS. See "Updating (flashing)
BIOS from a disc" on page 203.
.
Chapter 8 Replacing FRUs
97