Routing Operation - Studer OnAir 1500 Operating Instructions Manual

5.6.4

Routing Operation

Input Routing
Output Routing
Date printed: 04.10.11
Input routing is either done with the channel's rotary encoder in INPUT global
view mode
Example: Routing a new source (MIC 2 instead of CD 1 to channel strip #6).
MIC 1
IN
DeEs
EQ
DYN
AUX
Unused Inputs
• Select INPUT global view mode and select the MIC input group with the
rotary encoder of channel strip #6.
• Press the corresponding
• Turn the rotary encoder again until the desired source is displayed in the
channel label display (MIC 2 in the example above).
• Press the
MIC 1
IN
DeEs
EQ
DYN
AUX
Unused Inputs
Now, the MIC 2 input is routed to channel strip #6, as shown above. All
channel settings are as they were set when this input was used the last time,
except for the fader value and the status of the ON and PFL keys; these are
not overwritten and remain in the current channel status before the re-routing
took place.
For output routing the user GUI is required; use the Routing Output page.
SW V4.0
OnAir 1500 Digital Mixing Console
(chapter 5.2.1.1), or in the user GUI's Routing Input page.
MIC 2
CD 1
IN IN
DeEs DeEs
EQ EQ
CD 1
DYN DYN
AUX AUX
6
key.
key again.
MIC 2
CD 1
IN IN
DeEs DeEs
EQ EQ
MIC 2
DYN DYN
AUX AUX
6
Operation 5-35