Starting Cold Engine - Echo PB-580 H/T Operator's Manual

OPERATION
Mixing Instructions
1. Fill an approved fuel container with half of the required
amount of gasoline.
2. Add the proper amount of 2-stroke oil to gasoline.
3. Close container and shake to mix oil with gasoline.
4. Add remaining gasoline, close fuel container, and remix.
Spilled fuel is a leading cause of hydrocarbon emissions. Some
states may require the use of automatic fuel shut-off containers
to reduce fuel spillage.
After use
• DO NOT store a unit with fuel in its tank. Leaks can occur.
Return unused fuel to an approved fuel storage container.
Storage - Fuel storage laws vary by locality. Contact your local government for the laws affecting your area.
As a precaution, store fuel in an approved, airtight container. Store in a well-ventilated, unoccupied building,
away from sparks and flames.
Stored fuel ages. Do not mix more fuel than you expect to use in thirty (30) days, ninety (90) days when a
fuel stabilizer is added.
Stored two-stroke fuel may separate. ALWAYS shake fuel container thoroughly before each use.

Starting Cold Engine

• Recoil starter: Use short pulls - only 1/2- 2/3 of rope length for starting. Do not allow the rope to snap back
in. Always hold the unit firmly.
• (PB-580H): Rotate spring loaded throttle arm downward to a comfortable operating position.
1. Throttle Lever
Move throttle lever (A) to IDLE position.
2. Choke
Move choke (B) UP to COLD START (
3. Purge Bulb
Pump purge bulb (C) until fuel is visible. Pump bulb an
additional 4 or 5 times.
4. Recoil Starter
Pull recoil starter handle (D) until engine fires, or a maximum
of 5 pulls
20
PB-580 H
) position.
For more information
scan this QR code.
PB-580 T
PB-580 H/T
A
X7505200600
© 11/2014 ECHO Inc.