Table of Contents
Advertisement
Chapter 4. Lenovo USB 2.0 Super Multi-Burner (With
LightScribe) hardware installation and removal in Windows
2000 and Windows XP
Windows 2000 and Windows XP operating systems have the native drivers for the Lenovo USB 2.0 Super
Multi-Burner (With LightScribe). Therefore, when this drive is connected, Windows will automatically
install the appropriate driver and the drive will be ready to be used. You do not have to perform any
special installation or removal procedures.
Attention:
v This drive will be recognized as "USB_MultiBurner3" by Windows Device Manager.
v In Windows 2000 operating systems, Service Pack 4 or later must be installed.
Removing the Lenovo USB 2.0 Super Multi-Burner (With LightScribe)
hardware
"Hot plug" is supported for the connection between the USB cable and the computer; therefore you don't
need to turn off the computer when you remove the Lenovo USB 2.0 Super Multi-Burner (With
LightScribe). Follow the procedure below for removing the Lenovo USB 2.0 Super Multi-Burner (With
LightScribe) for Windows 2000 and Windows XP.
Attention:
Do not remove and reconnect the drive from or to the computer in rapid succession. The drive may not be
recognized. Reconnect the drive approximately 20 seconds after removing.
Use the Tray icon for this procedure.
Windows 2000
1. Exit the program that uses the drive.
2. Confirm that the Write indicator of the drive is off.
3. Click the Remove icon on the tray.
4. Select removing drive. In this case, select the drive name assigned to the drive (D: in this figure).
5. The Safe to Remove Hardware confirmation window appears. Click the OK button.
6. Remove the plug of the USB cable from the USB terminal of the computer.
© Lenovo 2006. Portions © IBM Corp. 2003.
4-1
Advertisement
Table of Contents
