Hardware And Software Requirements; Preparing To Use The Lenovo Usb 2.0 Super Multi-Burner Drive (With Lightscribe) - Lenovo 41N5631 User Manual

Hardware and software requirements

You must have the following hardware installed on your host computer in order to use this option:
v Available USB 2.0 port
Your computer must have one of the following operating systems installed to use this option:
® ®
v Microsoft Windows
v Microsoft Windows 2000 (Service Pack 4 or later)
Note: The drive will not operate correctly unless Service Pack 4 or later is installed.
Preparing to use the Lenovo USB 2.0 Super Multi-Burner Drive (With
LightScribe)
Before using the Lenovo USB 2.0 Super Multi-Burner Drive (With LightScribe), follow the procedure
below:
1. Make sure the Lenovo USB 2.0 Super Multi-Burner Drive (With LightScribe) is properly connected to
your host computer (Please refer to the "Power mode configurations" on page 1-5).
2. Check the locations of the functions on the Lenovo USB 2.0 Super Multi-Burner Drive (With
LightScribe) (refer to the figures below).
3. Insert the Lenovo USB 2.0 Super Multi-Burner Drive (With LightScribe) Software and User's Guide Super
CD that was shipped with this option to install the CD-R/CD-RW/DVD writing software.
4. Double-click on the application you want and follow the instructions on the screen.
5. Check that the drive operates normally and keep the enclosed warranty in a safe place after filling it
in.
Following are the locations of the functions on the host USB 2.0 Super Multi-Burner Drive:
1 Disc tray
2 DC IN connector
3 USB connector
1-4
Lenovo USB 2.0 Super Multi-Burner Drive (With LightScribe) User's Guide
XP
Firmly seat the media with the label face up on the disc tray.
Attention: Push the CD/DVD media down until it clicks and is secure in the
center.
Connect the provided AC adapter into the DC IN connector.
Insert the plug of the provided dedicated USB cable.