Advertisement
SET UP YOUR MONITOR FIRST
STEP 1
1
2
3
lEFT
RIGHT
ClICK
ClICK
www.digimerge.com
Connect Cameras to the monitor:
Your can connect up to 16 BNC
cameras (not included) to your
system.
TIP: Test the cameras prior to selecting a permanent
mounting location by temporarily connecting the
Cameras and Cables to your System.
Connect the first camera to the CH1
input. Follow the same steps to connect
the additional cameras.
The Octopus Cable (provided with the system)
allows 8 additional BNC cameras to be added
to the system representing 9 and 16 channels.
Connect Ethernet Cable:
Connect one end of the Ethernet cable (for remote
monitoring) to one of the router's (not included) LAN
ports and the other end to Monitor's Network Port
located at the back of the Monitor.
See picture below showing a generic LAN/WAN
connection.
WAN
LAN (LOCAL AREA NETWORK)
(WIDE
AREA NETWORK)
BACK OF THE ROUTER
TO YOUR MONITOR
TO YOUR COMPUTER
Connect the mouse:
Connect a USB mouse to one of the USB
ports located at the side of the monitor.
4
1
5
1
2
3
4
under 15 minutes
under 30 minutes
BASIC INSTALLATION GUIDE
Hand Tools
Time
Tools
Skills - Easy
Under 20 Minutes*
hand Tools
* Installation time may vary based on
application and camera cabling
Skill Level
Connect Power Cable:
easy
Connect one end of the Power adaptor to the monitor,
the other end to an electrical outlet.
Your system will perform the following System Check:
1. Blue LED at the front flashes four times
2. You will hear 2 beeps
3. Power LED at the front turns RED
PrESS ThE POwEr buTTON ON
Your system will load with screens shown below.
NOTE: THIS MAy TAKE UP TO 15 SECONDS. PlEASE wAIT
UNTIl THE SySTEM COMPlETES lOADING.
3
2
Monitor Front Panel - Power Button
Set the Time and date***:
Time and Date can be set by
• Pressing the SETUP button from the front panel of the monitor
• Pressing the SETUP button from the remote control (or) by
• Using the mouse navigation (recommended)
1. Right click the mouse and select SETUP and click on SYSTEM SETUP
2. On SYSTEM SETUP MAIN Menu, select SYSTEM
3. Click on the DATE/TIME menu and use the UP and DOWN arrows to
change the DATE/TIME.
4. Click Apply. The system will prompt you for default USER ID and
PASSWORD.
MAKE SURE THAT THE
DATE AND TIME ARE SET
PRIOR TO RECORDING!
THE DEFAULT USER IS ADMIN
THE DEFAULT ADMIN PASSOWRD IS 124
Congratulations!
You have completed Step 1 successfully.
You can now view, record and playback
images on your monitor.
D221600 SERIES Quick Start Guide_R1
R
under 60 minutes
over 60 minutes
Skill Level
Hardware
Hi Speed
Router
easy
Intermediat
Plug & Play connectors,
On screen set up
Intermediate
advanced
*** NOTE: IF THE DATE/
TIME IS SET INTO THE
PAST, A MESSAGE wIll
APPEAR wARNING THAT
OvERlAPPED DATE(S)
wIll BE ERASED.
Page
Advertisement
