Re Nstallation; Eatures Ackaging Atings - Lennox Hearth Products Gas Stove Installation And Operation Manual

Pre-Installation
f
eatures
Installation Options
Residential
Vented vertical and horizontal
Manufactured (mobile) home
Natural gas (NG) or propane (LP)
Bedrooms
Optional wall-mounted or remote thermostat
Venting
This stove can be vented with Security™ Secure Vent™
pipe*. Coaxial pipe diameters are 6-5/8" outer and 4" inner.
The combustion air for this stove is drawn from outside the
house through the outer DV (direct vent) pipe. Room air is
not required for combustion.
When planning your installation, select the correct length of
vent pipe for your particular requirements. Determine the
minimum clearance to combustibles from the rear of the
unit to the wall. It is also important to note the thickness
of the wall. Before cutting the vent hole through the wall
make sure that ALL vent and termination clearances (see
page 15) will be met.
Electrical
The standard fan motor requires 120 Volts AC for operation.
The stove is not dependent on the fan or an outside electri-
cal supply to operate. WARNING - Electrical Grounding
Instructions - This appliance is equipped with a three-
prong (grounding) plug for your protection against shock
hazard and should be plugged directly into a properly
grounded three-prong receptacle. Do not cut or remove
the grounding prong from this plug.
* Other approved chimney brand is Simpson Dura-Vent DV-GS.
Max/Min Input BTUh 0-,000 Feet
(0-10 M)
u
Manifold Pressure (IN. WC)
Min. Inlet Pressure (IN. WC)
Maximum heat output BTUs/hour-steady state
P4 Efficiency
O
rifice (DMS) 0-,000 Feet (0-10 M)
Unit factory equipped for 0-000 FT/0-10 M, In Canada 0-4500 FT/0-170 M
u
The Steady State Efficiency numbers based on maximum vent configuration.
v
Tested to CSA P.4.1-0 "Testing Method for Measuring Annual Fireplace Efficiency.
w
Electrical Rating: 10 VAC, 0 HZ, Less Than  Amps

RATINGS
w
u
Millivolt Valve
This stove is operated with a millivolt valve and therefore
burns even during a power outage.
Fuel
This stove comes from the factory equipped to burn natural
gas at a specified elevation. The stove can be converted to
burn LP gas (liquid propane) by changing the cassette (valve
and pilot assembly) or installing a conversion kit. Only Len-
nox Hearth Products conversion kits can be used to convert
from NG to LP or LP to NG. Contact your Lennox Hearth
Products dealer for details.
Specifications
Pipe:Type - direct-vent
Recommended manufacturer*
Security™ Secure Vent*
Diameter - 6-5/8"x 4" for all installations
Stove Packaging List
The Vision™ gas stove comes with the following parts:
1 Stove Body with Burner Cassette
1 150 CFM Blower
1 3/8"x 8" Gas Pipe
1 Brick Panel
1 Log Set
1 Bag of Ember Material
1 Installation and Operation Manual
Options
• Wall-mounted or Remote Thermostat
• Painted, Gold, or Nickel Plated Door Trim & Grill Assembly
(required)
Vision™ 35 (VIS35)
NATURAL GAS LP GAS
35,000/23,000 35,000/23,500
3.5 10.0
5.0 11
9,050 9,050
1.5% 5.74%
#34 (.111 IN.) #50 (.070 IN.)
Vision™ 25 (VIS25)
NATURAL GAS LP GAS
25,000/17,500 25,000/18,000
3.5 10.0
5.0 11
0,750 0,750
5.08% .5%
#42 (.093 IN.) #53 (.059 IN.)