Preparing The Media; Disc & Usb; Bluetooth - Panasonic SC-HC29 Operating Instructions Manual

Preparing the media

Disc
1
SC-HC29
Press [USB/CD] to select "CD".
SC-HC19
Press [CD].
2
Press [CD x] (main unit: [x OPEN/CLOSE]) to open
the sliding door.
Put in a disc with the label facing towards you.
3
Press [CD x] (main unit: [x OPEN/CLOSE]) again
to close the sliding door.
Keep fingers away from the sliding door when it is
closing.
USB
USB device
(not supplied)
SC-HC29
Press [USB/CD] to select "USB".
SC-HC19
Press [USB].
Note:
Do not use a USB extension cable. The system cannot
recognise USB device connected through a cable.
®

Bluetooth

SC-HC29
You can connect and play an audio device wirelessly
through Bluetooth .
®
Preparation
• Switch on the Bluetooth
the device near the system.
• Read the operating instructions of the device for
details.
® feature of the device and put
█
Pairing a device
Preparation
If this system is connected to a Bluetooth
disconnect it (Z"Disconnecting a device").
1
Press [ ] to select "BLUETOOTH".
If "PAIRING" is shown, continue with step 4.
2
Press [PLAY MENU] to select "PAIRING".
Or press and hold [
"PAIRING" is shown. Continue with step 4.
3
Press [R, T] to select "OK? YES" and then press [OK].
"PAIRING" is shown.
To cancel, select "OK? NO".
4
Select "SC-HC29" from the Bluetooth
device.
If prompted for a passkey, input "0000".
The device connects with this system automatically
after pairing is complete.
The name of the connected device is shown for a few
seconds.
Note:
You can pair up to 8 devices with this system. If a 9th device
is paired, the device that has not been used for the longest
time will be replaced.
█
Connecting a device
Preparation
If this system is connected to a Bluetooth
disconnect it (Z"Disconnecting a device").
1
Press [ ] to select "BLUETOOTH".
"BLUETOOTH READY" is shown.
2
Select "SC-HC29" from the Bluetooth
device.
The name of the connected device is shown for a few
seconds.
3
Start playback on the device.
Note:
• A device must be paired to connect.
• This system can only connect to one device at a time.
• When "BLUETOOTH" is selected as the source, this
system will automatically try to connect to the last
connected device.
█
Disconnecting a device
1
Press [ ] to select "BLUETOOTH".
2
Press [PLAY MENU] repeatedly to select
"DISCONNECT?".
3
Press [R, T] to select "OK? YES" and then press [OK].
"BLUETOOTH READY" is shown.
To cancel, select "OK? NO".
Using the main unit
Press and hold [ –PAIRING] until "PAIRING" is shown.
Note:
A device is disconnected when you:
• Select a different source.
• Move the device out of the maximum range.
®
• Disable the Bluetooth
• Switch off the system or the device.
® device,
–PAIRING] on the main unit until
® menu of the
® device,
menu of the
®
transmission of the device.
7