Table of Contents
Advertisement
Spray Application
After completing the filling process, you are
now ready to start spraying�
NOTE: It is the responsibility of the
operator to ensure that the chemical mix is
sufficiently agitated and that the conditions
are right to start spraying� Operators must
wear the appropriate PPE�
1� Switch "On" pump
2� Allow pump to build pressure
3� Engage the trigger on the spray lance
to start spraying
4� Adjust the nozzle pattern as required
by rotating the nozzle in the
appropriate direction as required
5� Use a consistent speed or swath
pattern to ensure even coverage of
the target, or adjust the method of
application according to your target
Agitation
Agitation should take place when filling
or through another method as deemed
suitable by the operator�
Flushing
The following information is provided as a
general guide for flushing your sprayer after
a spray application
For more specific information regarding
flushing, and decontamination, specific
to the products that you are applying,
it is recommended that you consult the
chemical label or your chemical supplier�
1� Turn pump off
3� Add a quantity of fresh water to main
tank and then drain�
4� Add a quantity of fresh water, and
decontaminating agents if required,
to main tank�
5� Turn on pump, and spray fresh water
through the lance / gun� This will
ensure that fresh water has circulated
through the pump and lance�
6� Drain remaining contents of fresh
water� The sprayer is now ready for
storage�
Storage
If the sprayer is to be stored for a long
period of time without use, there are
several tasks that need to be performed�
1� Clean the sprayer thoroughly as
described under "flushing"
2� Store the sprayer out of direct
sunlight and where it will not be
affected by frosts
3� Ensure that the main tank is empty
4� Protect hoses and electrical
connections
5
Advertisement
Table of Contents
