No liability or responsibility is accepted or implied as a result of any information or advice tendered in this operating manual or by Goldacres its agents or employees� The end user accepts all responsibility arising from that advice�...
Empty pump of all water and cover the application rates or nozzle types in this pump to ensure this situation does not operator’s manual� Goldacres suggest the arise� If this has not been done, and there use of a current nozzle selection catalogue...
Operation Calibration All sprayers need to be calibrated and kept Connections in good condition� This will ensure that the The following steps should be followed when correct rate of chemical is applied to the connecting to a power source: target� 1�...
Spray Application it is recommended that you consult the chemical label or your chemical supplier� After completing the filling process, you are 1� Turn pump off now ready to start spraying� 3� Add a quantity of fresh water to main NOTE: It is the responsibility of the tank and then drain�...
Identification When ordering parts or requesting service information for your sprayer it is important to quote the serial number of your machine, and the purchase date, in order to receive accurate information� The location of the serial number is shown in the picture� This serial number is stamped into the serial number plate�...
MAINTENANCE & TROUBLESHOOTING FOR 12V UNITS The troubleshooting information is provided as a reference when your sprayer is not functioning correctly� To ensure that you receive the best possible service, it is recommended that you exhaust all applicable troubleshooting solutions shown prior to calling your dealer for service advice�...
PARTS LIST ATV200/3 ATV300/4 GA4905995 GA4905975 Position Part No Description Quantity GA4515600 ATV tank support mount GA5023670 Mini hub & stub ass GA5023665 Tyre nobby (22x11-8 x 6 ply) & 4 stud mini rim 300120 Filter, basket type, diam 305 x 245 deep GA8500000 Tank, 200L, ATV low profile, green GA5023660...
Page 9
Position Part No Description Quantity GA5066085 15 mtr hose reel manual, 3/8” GA5053250 Pressure gauge, small face, 0-400kPa GA4900546 Gunjet, AA30, adjustable nozzle with fittings GA5015971 Sticker Drain Only GA5020620 Valve, ball, 12mm thread male/female inlet/ outlet, lever handle, SS HB050-90 Hose barb, Elbow, 90 degree, 1/2 male thread x 1/2 hose, Banjo (not shown)
12v pump wiring diagram Important: Use 14 gauge stranded wire up to 6 metres from power source and 12 gauge up to 18 metres from power source� Connect Red to Positive (+) terminal and Black to Negative (-) terminal� Pump Diagrams Spare parts available for GA5066540 Pathway 13.5 Lt/min pump: GA5068305 Pressure switch...
Wheels & Tyres To determine the correct tyre pressure: 1� Determine the maximum weight of the All tyres used on Goldacres sprayers have sprayer when loaded (do not forget to add been designed to carry the maximum the weight of the rinse water tank and the loaded weight of the sprayer when travelling foam marker tank when filled)�...
MANUAL FOLDING BOOMS Boom height The standard nozzle spacing on Goldacres General information booms is 500mm� For this spacing, the The boom fitted as standard is part of the optimum height the boom should be from Goldacres range of “folding booms” which the object to be sprayed (with a 110°...
Page 15
Operating instructions for Folding boom lubrication folding booms Folding booms have a grease nipple fitted at each pivot point� Grease these points 1� Starting with the boom in the closed regularly with quality multi purpose grease� position (Fig�1), pull each wing against the spring in an out and down manner until open and resting against the stop plate with the adjustment bolt�...
Adjustable ConeJet Nozzle The adjustable brass ConeJet nozzle rotates through a half turn to provide spray selection from wide angle, finely atomized cone spray to a straight stream spray� Tip settings “A” and “B” represent two extreme points of rotation in tip adjustment� ADJUSTABLE PERFORMANCE LIQUID PRESSURE (bar)
ATV� • Ensure the ATV or vehicle complies with Safety is Goldacres primary concern in the design, manufacture, sale, and use of this ATV spray tank all relevant road regulations for use on and other equipment�...
The following pages outline important not exceed the carrying, braking and/or safety information� At Goldacres safety is towing capacity of the vehicle to which a high priority� These safety and warning the equipment is attached as specified instructions MUST be followed to ensure by the vehicle manufacturer�...
• Always read and understand the trained in the safe use of Ag chemicals� operator’s manual prior to operation of Goldacres suggest that a relevant course this equipment� is completed by owners/operators prior to • It is the responsibility of the operator to operation of this equipment as a spray unit�...
It is very important to ensure that all new machine components and replacement parts include current hazard identification decals� Replacement safety decals can be ordered from all Goldacres dealers� GA5063371 GA5063371 decal GA5015971 EVO_R2 decal GA5013 EVO_R2 decal DRAIN...
Page 23
GA8700118 ATV 200 tank decal GA5065005 ATV 300 tank decal GA5065065 UV400 tank decal...
Interest on overdue payments the defects have arisen solely from faulty materials or workmanship; 15� If Goldacres is not paid for any Goods or services on the due date specified in this (ii) the Goods have not received maltreatment inattention or interference;...
Page 25
Goods (section 132(2)); trustee for Goldacres by way of bona fide sale at full market value and in the ordinary to receive a statement of account if no disposal of Goods for each 6 month period course of its business�...