GE Pro Elite RO-450 Installation, Operation & Service Manual page 9

5. Place the Toggles of the Monitor Housing
Assembly through the mounting hole on the sink or
counter top.
Drop the handle of the Wrench through the Monitor
Housing opening. This will separate and orient the
Toggle Wings. Position the Monitor Housing so that
the display is facing forward.
Tighten the 1/8" Screws with a Phillips tip
screwdriver. When the Toggle Wings make contact
with the mounting surface, adjust the Monitor
Housing to the exact desired position. Tighten the
1/8" Screws an additional 2 –3 turns while holding
the Monitor Housing in place.
Drop the Monitor Cord back through the Monitor
Housings opening.
3/8" QUICK
CONNECT FITTING
BLACK 1/4" POLYTUBE
(TO DRAIN PORT
ON RO SYSTEM)
BLUE 3/8" POLYTUBE
(PRODUCT OUTLET)
6. Connect the tubing to the Faucet. Push the Blue
3/8" Polytube into the 3/8" Quick Connect Fitting.
Push the Black 3/8" Polytube onto the large Hose
Barb. Push the Black ¼" Polytube onto the small
Hose Barb.
TAB
HOSE BARBS
BLACK 3/8" POLYTUBE
(TO DRAIN CLAMP)
7. Determine which direction the handle should
face (right or left). With the handle facing the
chosen direction, slide the fastened Polytubes
through the Monitor Housings 1 ¼" diameter
opening and slide the Faucet Assembly into the
Monitor Housing, lining up the tabs of the Faucet
with the slots on the Housing. The Faucet Assembly
may have to rotate slightly to get the tabs into the
slots. When aligned, apply firm downward force
to get the Faucet to fully seat. After the Faucet
Assembly is seated, lock it into place by rotating it
clockwise about 30 degrees.
9