Gl2 Menu - Epson AcuLaser C4000 Owner's Manual

GL2 Menu

This menu lets you set the printer to emulate a plotter, allowing
you to use software which requires a plotter for output. The
LJ4GL2 mode is similar to the GL/2 mode supported in the HP
LaserJet 4 mode. The GLlike mode emulates some of the HP-GL
plotter commands and includes all the commands found in HP's
GL/2 mode, as well as two additional commands.
Item
GL Mode
Scale
Origin
Pen
End
Join
Pen 0 through 6
* Available only when GLlike is selected as the GL Mode.
Before you start printing in the GL/2 mode
You may need to change the following print options in your
application, depending on your output needs. Check these
settings to make sure they match the data you are trying to print.
Print Options
Paper size
Driver (plotter
selection)
Pen configuration
200
Functions of the Control Panel
Settings (default in bold)
LJ4GL2, GLlike
Off, A0, A1, A2, A3
Corner, Center
Pen0, Pen1, Pen2*, Pen3*, Pen4*, Pen5*,
Pen6*
Butt, Square, Triangular, Round
Mitered, Miteredbeveled, Triangular,
Round, Beveled, None
0.05 ... 0.35 ... 5.00 mm in 0.05-mm
increments
Settings
Printer's paper size setting
HP-GL/2 or HP-GL
Pen thickness