Practical Advice On How To Use The Refrigerator/Replacement Parts - Hitachi R-S47AMJ How To Use Manual

PRACTICAL ADVICE ON HOW TO USE THE REFRIGERATOR/REPLACEMENT PARTS

The "Check"
display fl ashes
on the Control
Panel for
operation
The electric
supply failed
The refrigerator
is not expected to
use for a long term
Remove frost
Moving house
Moving or carrying
the refrigerator
When you want
to adjust the
temperature
more fi nely
REPLACEMENT PARTS
When replacing the following parts, make sure to tell your dealer the type name and buy the special parts.
Replace the water fi lter when it becomes old.(Replace it normally once 3
Ordering the replacement water fi lter
Tell your dealer the parts number: RJK-30 to buy the replacement water fi lter. (Ice making capacity is the same with
a water fi lter removed.)
54
This fl ashing shows that there is a problem with the Automatic Ice Maker, the temperature control device or
the frost removal device etc.
Consult your dealer if the fl ashing does not stop even after checking the point listed in the following table.
Flashing pattern
"Check" fl ashing
Flashing
3 times
"Check" fl ashing
(excluding fl ashing
3 times)
"Large"
"Normal"
"Stop"
Flashing
"Stop" fl ashing
All displays fl ashing
Reduce the number of times of opening and closing the door and avoid storing food additionally until the
electric supply is restored.
Unplug the power plug and maintain the inner of the refrigerator and the Automatic Ice Maker, and leave all
the door open to dry the refrigerator for 2
Any operation to remove frost is not required because this refrigerator remove frost automatically.
Thawed water is collected in the evaporating tray and automatically evaporates.
Refer to When moving or carrying section.
You can adjust "MIN"/"MID"/"MAX" more fi nely when setting the temperature
in the Refrigerator Compartment and the Freezer Compartment.
1. Open the Lower Freezer Door.
2. Push the Quick Cooling button on the control panel on the refrigerator door
for more than 5 seconds until single long beep sounds.
3. Push the Cooling button or the Freezing button to adjust the temperature.
The temperature becomes lower by 1 step every time you push the button.(If
you push the button when "MAX" is selected, the setting returns to "MIN".
4. If you want to stop the fi ne adjustment, perform the operation of 1 and 2.
Two beeps sound and You can set the temperature by normal step.
Replacing the water fi lter
Possible Cause
Food etc. may come in contact with the ice
tray or the stored ice amount detection lever.
This fl ashing shows that there is a problem.
It is in process of Ice Maker Cleaning.
It will fl ash if you stop ice making during the
ice making process.
Door remains open for more than 1 minute. (ex:
door is not completely closed.)
3 days.
Pg.33
Check Point
Empty the Ice Compartment and perform
"Cleaning the Ice Making".
Consult your dealer.
Check the points described in "How to
maintain the Automatic Ice Maker" on P.48.
Check the points described in "Ice Tray" on
P.49.
Check the points described in "Door Alarm"
on P.37.
Pg.45 49
MIN MID-
Temperature setting
4 years.)
（低溫） （低溫）
MID MID- MAX
MIN MAX