Bluetooth - Kenwood KDC-BT310U Instruction Manual

BLUETOOTH®
You can operate Bluetooth devices using this unit.
Built-in microphone position
If you turn off the unit or detach the control panel during
a phone call conversation, the Bluetooth connection is
disconnected. Continue the conversation using your mobile
phone.
Supported Bluetooth profiles
• Hands-Free Profile (HFP)
• Serial Port Profile (SPP)
• Phonebook Access Profile (PBAP)
• Object Push Profile (OPP)
• Advanced Audio Distribution Profile (A2DP)
• Audio/Video Remote Control Profile (AVRCP)
Pair a Bluetooth device
When connecting a Bluetooth device to the unit for the first
time, perform pairing between the unit and the device. Once the
pairing is completed, the Bluetooth device will remain registered
in the unit even if you reset the unit.
• Up to five devices can be registered (paired) in total.
• A maximum of two Bluetooth phones and one Bluetooth audio
device can be connected at any time.
• This unit supports Secure Simple Pairing (SSP).
• Some Bluetooth devices may not automatically connect to the
unit after pairing. Connect the device to the unit manually.
Refer to the instruction manual of the Bluetooth device for
more information.
1 Press L SRC to turn on the unit.
2
Search and select this unit model name (KDC-BT3**U) on the Bluetooth
device.
"PAIRING" \ "PASS XXXXXX" \ Device name \ "PRESS" \ "VOLUME KNOB"
scrolls on the display.
3 Press the volume knob to start pairing.
"PAIRING OK" appears when pairing is completed and "BT" will light up when
the Bluetooth connection is established.
• For some Bluetooth devices, you may need to enter the Personal Identification
Number (PIN) code immediately after searching.
• Pairing request (via Bluetooth) is automatically activated if an iPhone/iPod
touch is connected through the USB input terminal.
(Applicable only if [AUTO PAIR] is set to [ON].) (➜ 11)
Press the volume knob to pair once you have confirm the passcode.
Bluetooth test mode
You can check the connectivity of the supported profile between the Bluetooth
device and the unit.
1 Press to enter Bluetooth mode.
2 Turn the volume knob to select [BT TEST], then press the knob.
"PLEASE PAIR YOUR PHONE" appears.
3 Search and select this unit model name (KDC-BT3**U) on the Bluetooth
device.
4 Press the volume knob to start pairing and begin the test mode.
"PAIRING" flashes on the display.
The connectivity result (OK or NG) appears after the test.
PAIRING: Pairing status
HF CNT: Hands-Free Profile (HFP) compatibility
AUD CNT: Advanced Audio Distribution Profile (A2DP) compatibility
PB DL: Phonebook Access profile (PBAP) compatibility
• To cancel, press .
ENGLISH | 9